Home > Error Code > Triton 9600 Atm Error Codes

Triton 9600 Atm Error Codes

Contents

Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support8100, 9100, 9600, 9700, 9800, Mako, RL1600, RL2000, RL5000, RT2000126Diverter moved to reject position during dispenseInspect for a If error persists; replace the dispenser mechanism. 376 Dispenser multiple device error. Place money in the hands of gamers with minimal effort and time. If it is necessary to check continuity of the cable assembly, refer to Appendix B for pin out of the cable assembly 5. navigate here

Open the printer support bracket and verify that there are no jams in the printer or the paper path. Reset the cash dispenser. If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5. If error persists; replace the dispenser mechanism. 371 Dispenser SDD com error header-trailer. https://prineta.com/atms/docs/atm-error-codes-triton-machines/

Triton Error Code 244

If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5 If the cables are undamaged Replace cassette or Inject New Cassette ID. 500 SPED Read Error. Clear the jammed documents.2. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support8100, 9100, 9600, 9700, 9800, Mako, RL1600, RL2000, RL5000, RT2000103Thickness sensor unstableEnter the diagnostic function and complete the

  1. Purge the dispenser with the purge command under diagnostics.
  2. Ensure the reject bin is empty, or that there is enough room for the rejects and test notes to fall into the reject bin.
  3. Telephone line may be noisy and in general has poor quality characteristics. 3.
  4. Clean as needed with soft brush and vacuum cleaner. 2.
  5. This status occurs when a note is detected by the exit sensor when it should not have been.
  6. When this is done, the terminal will operate normally until it is completely out of paper.

This error code is generated when the LIFTS UP command fails to open a note cassette to the operating position. Inspect cable from the Electronic Journal to the dispensing mechanism to be sure both ends are securely screwed in place. Inspect the note transport for damage and verify that all connectors are plugged into their respective receptacles. Triton Error Code 139 Requested amount may exceed the dispensers one time limit.

Inspect for jammed currency in the transport path between the width sensors and the reject sensor. Triton Error Code 151 Restart operating system. Clear the error. check it out If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5.

Make sure all connections between the double detect module and the CMC are seated properly. Mitsubishi Triton Error Codes Other components that may cause this error are the main board or the dispensing mechanism.8100, 9100, 9600, 9700, 9800, Mako, RL1600, RL2000, RL5000, RT2000129No response from the dispenser mechanism1. Verify that there is paper in the printer. See Recommended Actions for Error Code 134 136 Modem initialization failed Reset the cash dispenser by turning OFF the AC power switch for a few seconds and switching it back ON.

Triton Error Code 151

This error code is reported when an internal error occurs in the dispenser. Status valid only for units with SPED keypad device installed. Triton Error Code 244 Inspect the cables connected to CN2; CN3; CN4; and CN5. Atm Error Codes List Valid for SDD and GND mechanisms only.With the low currency feature enabled, this error condition will occur before the cassette is actually empty.

If the cables are undamaged, the main board or electronic journal may be defective8100, 9100, 9600, 9700, 9800, Mako, RL1600, RL2000, RL5000, RT2000159Electronic journal test feature failed1. check over here It can occur if there are notes already in the transport before the start of a transaction or if the exit sensor is blocked. 1. Baud rate set to high for telephone line conditions. If two or more of the same type cassette are installed; inject a new cassette ID into one of the cassettes that is different from the other cassette. 101 (65h) 2-second Triton Atm Error Code 101

Inspect the feed path for notes stuck together or jammed. Make sure the documents are fit condition. Refer to error 500. 511 SPED Data overflow. his comment is here Restart the cash dispenser.

Telephone line may not be dedicated. (ATM is being used with another devices connected to the line. 2. Triton Traverse Error Code 917 Remove any jammed currency.3. Make sure the connectors are seated securely on the main board and on the electronic journal. 2.

Verify that the DC voltages to the dispenser are correct.

Verify that the cable that connects the double detect module to the CMC module is undamaged and connected at both ends. Inspect the detent clips (the clips that hold the cassette in place). Replace the dispenser if the error persists.8100, 9100, 9600, 9700, 9800, Mako, RL1600, RL2000, RL5000, RT2000167Reported low cash to Triton ConnectThis is an indication that the cash in the cassette has Triton 9100 Error Code 148 Remove any jammed currency. 2.

Replace the dispenser if it is broken. Learn More MERCHANT SERVICES ATM Merchant Systems offers a full line of credit card terminals and merchant account services to meet your processing needs. If the problem persists, remove the main board and replace the modem. 3. weblink Test the dispenser by completing several test dispenses. 5.