Home > Error Code > Triton 9700 Atm Error Codes

Triton 9700 Atm Error Codes

Contents

This error code is generated when a cassette is emptied during a dispense operation and does a partial dispense. Purge the dispenser using the purge command from diagnostic menu. 2. If these actions have no effect on dispenser operation; replace the dispenser mechanism. 114 (72h) Exit blocked during purge 1. This status is reported if the exit sensor is covered for a longer that allowed time for the current notes. 1. his comment is here

Restart ATM. Make sure the connectors are seated securely on the main board and on the electronic journal. 4. If the voltages are not within tolerance; you may need to replace the cable or power supply. Clear any jammed currency. 2.

Triton Error Codes

If the test dispenses pass, but the error returns upon live dispenses, do dispenses with the vault door open. The dispenser sends this status code when a command has been successfully executed. Verify that the power supply is operating and the DC voltages being supplied to the main board and dispenser are correct. Clean as needed with soft brush and vacuum cleaner. 2.

  • Inspect main board to electronic journal communication cable for damage.
  • If error persists; replace the dispenser mechanism. 379 Dispenser unknown error code.
  • Replace the dispenser is the error persists. 359 Dispenser device record error.
  • Verify that the diverter moves freely.
  • No money is dispensed; screen and receipt display system unavailable. 1.
  • Inspect main board to electronic journal communication cable for damage.
  • If the error code persists; replace the note transport module. 343(5Bh)[[] Sensor error or sensor covered.
  • Clear all errors and test the dispenser with a live transaction.
  • Inspect for jammed Currency in the feed path and at the Exit sensor.
  • Replace dispenser components or dispenser if the error persists. 392 Error in last dispense.

If EOT is received on subsequent attempts; then Error Code 1 is reported. (If problem persists call Your Service Provider or Triton Tech Support). 15 Timed out waiting for EOT See If it works with the door open, remove obstruction causing the diverter to contact the vault door. 4. Verify the quality of your incoming TCP-IP connection and your TCP-IP configuration. Triton Atm Error Code 101 Reset the cash dispenser by turning OFF the AC power switch for a few seconds and switching it back ON.

If the error does not repeat again; complete a live dispense to verify the note diverter moves the currency to the exit position. This error code occurs when documents are requested from a cassette that is not present or is not open. Inspect for a jammed currency in the reject sensor. 2. http://www.atmnetwork.net/support/troubleshooting/Triton9700.asp If these actions have no effect on dispenser operation, replace the dispenser mechanism.

Telephone line may be noisy and in general has poor quality characteristics. 3. Triton Traverse Error Code 917 If the error clears, put the cash dispenser in service. 5. Verify that the power supply is operating and the DC voltages being supplied to the main board and dispenser are correct. It the error clears put the cash dispenser back in service.

Triton Error Code 151

This is a Triton Connect error. https://www.nasatm.com/error_codes/code/144/ This status is reported if the exit sensor is covered for a longer that allowed time for the current notes.1 Inspect the note transport and delivery throat make sure all belts Triton Error Codes Consider sending the dispenser to repair to have new sensors installed. 38 Blocked exit This status appears if the exit sensor is covered or defective when the dispenser starts. 1. Triton Atm Error Code 245 Release the printer locking screw.

Clear the error. this content Verify that main board to electronic journal and the electronic journal to dispenser cables securely seated at both ends of the cable. Generated Wed, 27 Jul 2016 11:27:28 GMT by s_rh7 (squid/3.5.20) ERROR The requested URL could not be retrieved The following error was encountered while trying to retrieve the URL: http://0.0.0.9/ Connection Make sure the connectors are seated securely on the main board and on the electronic journal. 4. Atm Error Codes List

Make sure the connectors are seated securely on the main board and on the electronic journal. 4. Refer to error code 535. 539 Card Reader ñ Invalid track. Cassettes are taken out of service because of feed failures or excessive rejects. 1. weblink Inspect main board to electronic journal communication cable for damage.

Perform the test dispense function several times (two or three). Triton Error Code 139 Refer to error 500. 503 SPED invalid command. Inspect the note diverter for proper operation and damage.

Verify that the communication line is operational.

Otherwise, replace the dispensing mechanism. Close vault door. If the error clears put the cash dispenser into service. Triton 9100 Error Code 148 Make sure the tamper screw is secure to the SPED module.

Clear the error. 5. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 107 Time out waiting for FIFO The dispenser is reporting the leading note has not cleared the Inspect the printer data cable for damage. check over here If these actions have no effect on dispenser operation, replace the dispenser mechanism and/or the note cassette.

The cash dispenser will attempt to complete the transaction from other cassettes. Otherwise; put the cash dispenser into service. 308(38h)[8] Illegal Command or Command Sequence. There should be approximately 1/4 inch of currency (about 60 bills) in the Cassette at this point. If these actions have no effect on dispenser operation; replace the dispenser mechanism. 128 Error in reply from the dispenser mechanism Inspect cable from the Backplane to the Electronic Journal to

Check operational error code of dispenser. If cash dispenser operates normally when performing the test dispense function; put the cash dispenser in service. Refer to error 522. 535 Card Reader ñ Data size error. Refer to error code 535. 548 Card Reader ñ End sentinel not found.

The width sensor may be dirty. Close the control panel door. Clear terminal error code. State by verify if this is associated with error code 151.

Make sure the connectors are seated securely on the main board and on the electronic journal. 2. Replace the power supply or dispenser DC power if either is defective. 3.