Home > Error Code > Triton 9700 Error Codes

Triton 9700 Error Codes

Contents

Make sure the connectors are seated securely on the main board and on the electronic journal. 4. Refer to error code 535. 537 Card Reader ñ Invalid Record. Inspect all cables for possible damage. Complete several test dispenses. this contact form

Make sure it is seated at the main board and at the printer control board at CN6. 5. If the error persists; replace the SPED keypad module. 206 SPED could not perform a successful command within SPED_MAX_ATTEMPTS tries Error code valid only for units with SPED keypad device installed. If the error persists in may be necessary to replace either the cassette or dispensing mechanism. If the cables are undamaged, the main board or electronic journal may be defective 155 Electronic journal modify record failure 1. news

Triton Error Codes

Clear the error. The default bill size is $0.00 187 Maximum withdrawal not configured correctly This amount cannot be more than 50 times the bill size selected. Verify that the power supply is operating and the DC voltages being supplied to the main board and dispenser are correct.

Otherwise, replace the dispensing mechanism. If the error clears put the Cash Dispenser into service. Make sure they are seated at the printer control board and not damaged. 6. Triton Atm Error Code 101 Ensure they are marked as audited. 3.

Clean the sensors if needed. Triton Error Code 244 If the voltages are correct, and the cables are undamaged and correctly connected, causes of this error may be a defective cable, a defective printer, printer control board or the main If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly. 3. http://www.atmnetwork.net/support/troubleshooting/Triton9700.asp This is done to indicate that the power has been off.

If the error clears; put the cash dispenser in service. 5. Triton Traverse Error Code 917 If the cables are undamaged, the main board or electronic journal may be defective 160 Electronic journal set featured failed 1. Inspect the incoming power and check for proper grounding 51 (33h) Suspect exit accountancy A mechanical failure has occurred. Clear the error.

Triton Error Code 244

Refer to error 500. 512 SPED device idle. https://www.scribd.com/doc/76278512/triton-errorcodes Test the dispensing mechanism by completing several test dispenses. Triton Error Codes Open the printer support bracket and verify that there are no jams in the printer or the paper path. Triton Atm Error Code 33 Inspect the note feeders and note qualifier for damage.

This error occurs when the logical sequence of the commands sent to the dispenser is not the one expected by the system. weblink Remove jammed currency. 2. On 32-bit machines (RL’s, FT’s, RT’s) the electronic journal can store as many as 32,768 records, it is recommended that you do not print the journal. If the voltages are correct and the blue lever is in the print position; the most likely causes of the error are the printer; printer control board; or the main board. Triton Error Code 151

If the sensor is not operating normally; replace the note transport module. 318(42h)[B] Too many notes requested. Seat connectors or replace the power supply as needed. 2. Replace the dispensing mechanism. 56 Link error 1. navigate here If the error clears put the Cash Dispenser into service.

Reset the cash dispenser and clear the error. Mitsubishi Triton Error Codes Inspect the transport before the double detect for jammed currency. The reject event counter can be reset by removing the reject vault from the dispenser and then putting it back into the dispenser. 321(45h)[E] Cassette data corrupted.

Replace the cassette. 2.

Remove the jammed documents as needed. If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5. Verify the blue lever on the left side of the printer in the print position. 3. Triton 9100 Error Code 148 Purge the dispenser using the purge command. 3.

If no jam is located; remove the first bill from the cassette. Verify the blue lever on the left side of the printer in the print position. 3. Request has been sent. his comment is here It is usually caused by attempting to dispense currency that is unacceptable or currency that has not been properly prepared. 1.

Purge the dispenser with the PURGE command. It is feasible that this error code could be generated even if the lifts are in the up position. Put more currency in the cassette and repeat the ìlearn note thicknessî command. 106 (6Ah) FIFO error The dispensing mechanism may have corrupt software. Results: If problem persists call Your Service Provider or Triton Systems Technical Support 95 Multiple cassettes of the same type This is a multi-cassette dispenser error. 1.

If the status clears and the return code are normal place the cash dispenser in service. If the cables are undamaged, the main board or electronic journal may be defective 153 Electronic journal mode 1. Test the dispenser by completing several test dispenses. 3. Open all access panels and inspect for jammed documents in note path between the note qualifier and note transport.

If the problem persists, remove the main board and replace the modem. 3. If the diverter has excessive binding or appears damaged, replace the dispenser.2. Once records have been viewed or saved, they need to be marked as audited. Replace the dispenser. 47 (2Fh) Note missing at double detect Inspect the feed path for notes jammed.

Make sure the connectors are seated securely on the main board and on the electronic journal. 2. Clear the error.