Home > Error Code > Triton Atm 9100 Error Codes

Triton Atm 9100 Error Codes

Contents

If no jam is located, remove the first note from the cassette. If the cables are undamaged, the main board or electronic journal may be defective 160 Electronic journal set featured failed 1. Open the ATM control panel. Verify that the dispenser mechanism has data and power cable connected. http://u2commerce.com/error-code/triton-9100-error-codes.html

Refer to error 500. 513 SPED device offline. If two or more of the same type cassette are installed; inject a new cassette ID into one of the cassettes that is different from the other cassette. 101 (65h) 2-second Restart the cash dispenser. The maximum withdrawal cannot exceed 50 time the denomination of the bill size in the cassette. 188 PIN working key not configured Enter the management functions and configure (download) the working http://www.accessatm.com/service/atm-error-codes/triton-error-codes/

Triton Error Codes

Verify that there are no documents jammed in the note diverter area. Inspect electronic journal to dispenser communication cable for damage. Make sure the connectors are seated securely on the main board and on the electronic journal. 2. Make sure the connectors are seated securely on the main board and on the electronic journal. 4.

This status occurs when a note is detected by the exit sensor when it should not have been. Verify that the both ends of each cable are securely connected to its termination points. Clear any jammed currency. 2. Mitsubishi Triton Error Codes Purge the dispenser with the PURGE command.

Either the VEPP was changed or the software was reloaded, such as when you do a VEPP upgrade, or if the VEPP was changed. 2. Triton Error Code 244 Inspect the note transport sensor for blockage. Remove any jammed currency. 3. If the error clears, go to Step 7.

The transaction will be completed with the customersí receipt indicating the amount of cash actually received. Triton Error Code 139 Inspect the note diverter in the note transport module. Other components that may cause this error are the main board or the dispensing mechanism. 134 Exit blocked as reported by status check 1. Replace if low or empty.

  • Refer to error 522. 529 EJ device offline.
  • Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 107 Time out waiting for FIFO The dispenser is reporting the leading note has not cleared the
  • Inspect the documents in each cassette to insure they are in fit condition.
  • Once the cause has been resolved, place desired cassettes into service and reset the error.
  • Leave a Reply Cancel reply Your email address will not be published.
  • Make sure the connectors are seated securely on the main board and on the electronic journal. 4.
  • Make sure the electrical connections to the timing wheel sensor are secure and the time wheel sensor is clean.

Triton Error Code 244

Clear terminal error code. https://www.nasatm.com/error_codes/code/124/ Refer to error 500. 515 SPED device attention stuck. Triton Error Codes Replenish the paper. Triton Error Code 151 Inspect the cables connected to CN2, CN3, CN4, and CN5.

Clear the error. weblink Solution: Open ATM vault. Test the card reader. Replace cassette or Inject New Cassette ID. 500 SPED Read Error. Atm Error Codes List

Reset the error. Verify that all access panels are closed and secured. It the status clears; place the cash dispenser in service. navigate here Complete a live transaction.

Home ATM Machines Genmega Onyx Series Onyx W Series G2500 Series GT3000 Series GK1000 Bill Payment G6000 Series Hantle 1700W Series C4000 Series T4000 Series Coin Goat Series Hyosung Halo II Triton 9100 Error Code 148 Seat connectors or replace the power supply as needed. 2. Verify the quality of your incoming TCP-IP connection and your TCP-IP configuration, (i.e.

Make sure the ribbon cable from the docking station go the card reader is fastened at both ends of the cable and the orientation of the cable is correct.

If these actions have no effect on dispenser operation; replace the dispenser mechanism. 113 (71h) Timeout waiting for trailing edge at reject 1. This error code will cause an ìOut of Serviceî condition. No characters were received. Triton Atm Error Code 101 Products I ATM News I Services & Support I Partner Programs I Terms of Use I Privacy Policy © 2000-2015 Triton Systems of Delaware, LLC.

Refer to error code 535. 540 Card Reader ñ Invalid message. Clear all errors and test the dispenser by completing several TEST DISPENSES. Verify clearance at the diverter. http://u2commerce.com/error-code/triton-9100-atm-error-codes.html If the error recurs; change the note feeder for the affected channel. 320(44h)[D] Reject cassette almost full.

If a foreign object is discovered, try to dislodge it using a thin, smooth strip of cardboard or wood (such as a tongue depressor) to remove the object.WARNING: DO NOT USE Inspect main board to electronic journal communication cable for damage. The cash dispenser will attempt to complete the transaction from other cassettes. If error persists; replace the dispenser mechanism. 376 Dispenser multiple device error.

Complete several Test Dispenses to verify correct operation. This error code will place the cash dispenser ìOut of Serviceî. Inspect electronic journal to dispenser communication cable for damage. This error will not put the cash dispenser ìOut of Serviceî.

Verify that all sensors are operation correctly. Error Code 182: Currency Cassette Low Solution: Unlock security cabinet. Make sure the connectors are seated securely on the main board and on the electronic journal. 4. If the error clears put the cash dispenser into service.

Remove any jammed notes.2. Restart the cash dispenser and reset the error. Inspect the printer data cable for damage. Access the management functions menu and lock all cassettes.

Restart the cash dispenser. If the cables are undamaged, the main board or electronic journal may be defective 162 Electronic Journal get serial number failed 1. Clear all errors and test the dispenser with a live transaction. Clear all error and purge the dispenser using the purge command.3.

I the status clears; place the cash dispenser in service. The modem or the main board may cause the problem. If error persists, replace the SPED keypad module. 207 SPED not detected This Error/Status Code is valid for units with SPED keypad device installed. 1. If the voltages are not within tolerance, the cable or power supply may be defective. 4.