If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5. Reset the cash dispenser. Remove any jammed notes.2. Recommended Action: An attempt to feed or dispense documents has been made when there is a note in the note transport throat. navigate here
If the test dispenses pass, but the error returns upon live dispenses, do dispenses with the vault door open. If these actions have no effect on dispenser operation, replace the dispenser mechanism and/or the note cassette. Otherwise, the possible causes of the problem may be a defective paper low sensor, or a defective printer control PCB. It will be necessary to replace the note qualifier. http://www.accessatm.com/service/atm-error-codes/triton-error-codes/
Recommended Action: See the recommended action for error code 128. If replacing the modem does not correct the problem, replace the main board. Turn the AC power OFF for a few seconds and then back ON to power cycle and reset the cash dispenser. 3. Remove jammed currency. 2.
The system returned: (22) Invalid argument The remote host or network may be down. Error Code: 46 (2Eh) Description: Exit quantified Recommended Action: This status appears when the count at the exit is greater than the number of documents requested. 1. Cassettes are take out of service for two reasons: A) Feed failure or empty. Mitsubishi Triton Error Codes Reply Leave a ReplyWant to join the discussion?
Seat connectors or replace the power supply as needed. 2. Atm Error Codes List Make sure the documents are fit condition. Clear all errors and test the dispenser by completing several TEST DISPENSES. https://www.tritonatm.com/service_and_support/error_code_lookup/index.php Inspect for jammed currency in the feed path and at the Exit sensor.
All Rights Reserved.
Error Code: 183 Description: Receipt paper low Recommended Action: Install a new roll of paper if needed. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 110 Trailing edge time- out at exit. 1. Triton Error Code 244 Verify that the power supply is operating and the DC voltages being supplied to the main board and dispenser are correct. Triton Error Code 151 Test the dispenser by completing several test dispenses.
If the error persists, replace the SPED keypad module. 205 SPED keypad reported tamper condition Status valid only for units with SPED keypad device installed. check over here Vibrations can cause this error. 4. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 107 Time out waiting for FIFO The dispenser is reporting the leading note has not cleared the Make sure the connectors are seated securely on the main board and on the electronic journal. 4. Atm Error Code 3-da000(80)
If the error clears, put the cash dispenser in service. 4. It the status clears, place the cash dispenser in service. Replenish paper as needed. his comment is here Recommended Action: Error code valid only for units with SPED keypad device installed.
If the voltages are correct, and the cables are undamaged and correctly connected, causes of this error may be a defective cable, a defective printer, printer control board, or the main Atm Error Codes 072 Inspect the dispensing mechanism for of damaged components or broken wires. 2. The maximum withdrawal cannot exceed 50 time the denomination of the bill size in the cassette. 188 PIN working key not configured Enter the management functions and configure (download) the working
If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5. Verify the blue lever on the left side of the printer in the print position. 3. Recommended Action: This error code is generated when the reject vault is not present or not properly installed. Triton Traverse Error Code 917 Error Code: 102 (66h) Description: Error (Pick Motor over current) Recommended Action: 1.
Error Code: 165 Description: Electronic journal not present. Clear the error. If the voltages are correct and the blue lever is in the print position, the most likely causes of the error are the printer, printer control board, or the main board. weblink If the error does not occur again put the cash dispenser in service.
Make sure it is seated at the main board and at the printer control board at CN6. 5. Verify that all access panels are closed and secured. If the error clears, put the cash dispenser in service. 5. Verify that all DC voltages applied to the printer control board are correct.
Error Code: 54 (36h) Description: Operation time-out Recommended Action: 1. Inspect main board to electronic journal communication cable for damage. Inspect the note diverter in the note transport module.