Home > Error Code > Triton Atm Error Code 134

Triton Atm Error Code 134


This error will place the cash dispenser ìOut of Serviceî. Verify that the both ends of each cable are securely connected to its termination points. Replenish paper as needed. If a cassette cannot be injected with a new ID; verify that the cable between the top feed channel and the CMC is in good condition and connected at both ends. http://u2commerce.com/error-code/triton-atm-error-code-148.html

Perform a live transaction. Refer to error code 535. 555 Card Reader ñ System timeout. Refer to error 500. 506 SPED invalid request. If the error clears; put the cash dispenser in service. 4. http://www.accessatm.com/service/atm-error-codes/triton-error-codes/

Triton Error Code 244

If the voltages are correct and the blue lever is in the print position; the most likely causes of the error are the printer; printer control board; or the main board. Release the printer locking screw. After about ten seconds, push the Power ON/OFF switch to the ON position to start the terminal. 3.

When this is done, the terminal will operate normally until it is completely out of paper. Remove the cassette and visually inspect for loose or disconnected connectors on both the upper and lower width sensor printed circuit boards. 3. Use the cash dispenser diagnostic functions to check the electrical operation of the sensor. Triton Atm Error Code 101 Verify the quality of your incoming TCP-IP connection and your TCP-IP configuration.

Inspect the printer data cable for damage. Atm Error Codes List Make sure the battery is seated secure in the battery holder. The cables may be defective. 3. When the indication that it is safe to turn off the terminal is displayed on the screen, push the Power ON/OFF switch to the OFF position.

Revenue Generation Increase Sales Increase Customer Inquiries Increase Branding Effectiveness Cost Effective Dynamic Control of Your Content No Paper Waste No Space Limitations Leverage Existing Content Contact Us Today: www.zem-media.com 844.804.1395 Mitsubishi Triton Error Codes Clear the error. If the cables are undamaged, the main board or electronic journal may be defective 148 Write to electronic journal failed Most probable cause, the electronic journal is full. Inspect the note diverter in the note transport module.

Atm Error Codes List

Inspect the note transport and delivery throat make sure all belts are on track and there are no documents jammed in the transport or exit areas.

Remove any jammed currency. 2. Triton Error Code 244 Clear the error. 3. Triton Error Code 151 This error code causes an ìOut of Serviceî condition.

Seat connectors or replace the power supply as needed. 2. weblink Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 107 Time out waiting for FIFO The dispenser is reporting the leading note has not cleared the If the error does not occur again, put the cash dispenser in service. Great rates with no hidden fees; ATM Merchant Systems offers long-term low processing rates you can count on paired with outstanding service and support you can trust. Triton Error Code 139

  • Perform the test dispense function several times (two or three).
  • Refer to Section 4 of the RL5000 Installation and Service Manual or the RL5000 Quick Reference Guide for instructions.
  • Clear the error.

If this does not correct the problem, verify that the paper low sensor is correctly attached to the paper bracket and that the cable between the paper low paper feed assembly Reset the terminal and clear the error. Inspect electronic journal to dispenser communication cable for damage. http://u2commerce.com/error-code/triton-atm-error-code-110.html Do several test dispense operations. 3.

Purge the dispenser with the purge command under diagnostics. Triton 9100 Error Code 148 If these actions have no effect on dispenser operation, replace the dispenser mechanism. Purge the dispenser using PURGE command.

Verify that the diverter moves freely. 3.

Test the dispenser by completing several test dispenses. Purge the dispenser with the PURGE command. Verify that main board to electronic journal and the electronic journal to dispenser cables securely seated at both ends of the cable. Triton Error Code 246 Turn the AC power OFF for a few seconds and then back ON to power cycle and reset the cash dispenser.

At least one character was received (ETX was never received). Other components that may cause this error are the main board or the dispensing mechanism. 131 CTS (Clear To Send) line from the dispenser is not active. 1. Make sure that there is no foreign material in the card slot. 2. his comment is here If the cash dispenser operates normally put it back in service.

Complete a live transaction. Consider sending the dispenser to repair to have new sensors installed. 38 Blocked exit This status appears if the exit sensor is covered or defective when the dispenser starts. 1. It the status clears, place the cash dispenser in service. If these actions have no effect; replace the dispenser. 45 (2Dh) Diverter error This error occurs when the diverter is in the wrong position during a dispense. 1.

If the error recurs; a faulty cassette; note feeder or CMC module may be cause the problem. 305(35h)[5] Diverter Failure. Replace the dispenser is the error persists. 366 Dispenser cassettes disabled. Restart the cash dispenser. for a four cassette dispenser.

Inspect the cable supplying DC power from the power supply to the printer. Starting at the top; you should find 24 volts; -12 volts; no pin; 5 volts; ground; 5 volts and ground. Make sure the connectors are seated securely on the main board and on the electronic journal. 2. Remove any jammed currency. 2.

If the error clears put the cash dispenser into service. Test the dispensing mechanism by completing several test dispenses. Purge the dispenser with the purge command under diagnostics. If these actions have no effect, replace the dispensing mechanism. 203 SPED keypad is not replying to main board Status valid only for units with SPED keypad device installed. 1.