Home > Error Code > Triton Atm Error Code 382

Triton Atm Error Code 382

Contents

Inspect electronic journal to dispenser communication cable for damage. Contact Us online form Error Code Lookup Lookup an error code by number or by the error description. If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5. If the error code is reported again, it may be necessary to replace the CMC or one of the note feeder controllers. this contact form

Complete several Test Dispenses to verify correct operation. 3. It can occur if there are notes already in the transport before the start of a transaction or if the exit sensor is blocked. 1. EOT from processor was not received within time out period. 2. This error will only apply to a Triton Machine with an NMD50 dispenser. this page

Atm Error Codes List

Replace the dispenser is the error persists. Examine the timing wheel for physical defect. Purge the dispenser using the purge command from diagnostic menu. 2.

Inspect the feed path for jammed currency. Clear the jammed currency. 2. This failure may be caused by a blockage in the transport path between the Note Feeder and the note qualifier, or if a document passes through the note qualifier unseen. Triton Atm Error Code 245 Verify that the cable that connects the double detect module to the CMC module is undamaged and connected at both ends.

Check the incoming power and dispenser mechanism for proper grounding. 2. Triton Atm Error Codes Error Code: 51 (33h) Description: Accountancy error Recommended Action: A mechanical failure has occurred. Make sure all connectors attached to the CMC are seated in their receptacles. If the error persists, possible causes of the problem may be the low paper sensor assembly, the docking station, the main board, or cables.

Recommended Action: Inspect the electronic journal to make sure is it the correct part number. Triton Error Code 151 Request has been sent. Can only be cleared in Diagnostics>Keypad>Clear Tamper. Recommended Action: Error code valid only for units with SPED keypad device installed.

  • Verify that the telephone line is operational.
  • If these actions have no effect, replace the dispensing mechanism.
  • Recommended Action: Error code valid only for units with SPED keypad device installed.
  • Inspect main board to electronic journal communication cable for damage.
  • If the cables are undamaged, the main board or electronic journal may be defective 161 Electronic journal clear feature failed 1.
  • If EOT is received on subsequent attempts, then Error Code 1 is reported Results: No money is dispensed, screen and receipt display system unavailable.
  • Perform a live transaction.

Triton Atm Error Codes

Remove jammed currency. 2. Test the dispenser by completing several test dispenses. 3. Atm Error Codes List If the error does not occur again, put the cash dispenser in service. Atm Error Code 3-da000(80) Inspect the reject vault present sensor visually for proper operation.

If the cables are undamaged, the main board or electronic journal may be defective 146 No reply from command to electronic journal 1. weblink Error Code: 114 (72h) Description: Exit blocked during purge Recommended Action: 1. If at any time during the following checks, the ""faulty note qualifier"" error code recurs. Recommended Action: This error code is generated when a movement command is sent before read cassette ID command after the cassettes, including the reject vault are removed. Atm Error Codes 072

Recommended Action: This error code is reported by the dispensing mechanism when a document is jammed in the throat sensor during a live dispenses or when a reset is performed. Modem response was good, but operation was not performed. 2. If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly. 5. http://u2commerce.com/error-code/triton-atm-error-code-148.html Inspect the diverter area to make sure that it is not blocked and that it moves freely.

Perform the test dispense function several times (two or three). Atm Error Code 3-da001 If error persists, replace the SPED keypad module. Inspect electronic journal to dispenser communication cable for damage.

Clear terminal error code.

Remove jammed currency. 2. I think my machine has been tampered with or there is someone acting suspiciously around the ATM. Error Code: 362 Description: Dispenser device write error. Triton Atm Error Code 101 Error Code: 133 Description: +5 VDC not present on carrier detect.

Inspect for jammed currency in the feed path and at the Exit sensor. Error Code: 360 Description: Dispenser invalid return ID. Clear all errors and test the dispenser with a live transaction. http://u2commerce.com/error-code/triton-atm-error-code-110.html Replenish paper as needed.

Inspect main board to electronic journal communication cable for damage. Remove each note feeder module from the dispensing mechanism and clean their associated empty, pressure and exit sensors with clean compressed air. Inspect for jammed currency at the Diverter. If the cables are undamaged, the main board or electronic journal may be defective 153 Electronic journal mode 1.

Inspect for jammed currency in the feed path and at the Exit sensor. Make sure the connectors are seated securely on the main board and on the electronic journal. 2. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 114 Exit blocked during purge 1. If the error does not repeat again, complete a live dispense to verify the note diverter moves the currency to the exit position.

Verify that the power supply is operating and the DC voltages being supplied to the main board and dispenser are correct. Clear the error. Error Code: 353(65h)[e] Description: No message to resend. If the test dispenses are normal and the status clears, place the cash dispenser in service.

Clear the error. Make sure the connectors are seated securely on the main board and on the electronic journal. 4. Recommended Action: Enter management functions and verify that all terminal parameters have been set correctly. If the test dispenses pass, but the error returns upon live dispenses, do dispenses with the vault door open.

Watch QueueQueueWatch QueueQueue Remove allDisconnect Loading... Make sure the connectors are seated securely on the main board and on the electronic journal. 2. Make sure the battery is seated secure in the battery holder. Clear any jammed currency. 2.

Error Code: 48 Description: NO ANSWER Possible Cause: 1. If you’re having a Through The Wall machine the process will take approximately eight weeks. When will my cash machine be cashed?The initial cash loading of a Fully Managed machine depends on various factors. If any sensor is out of its calibration limits, clean all of the sensors and attempt to do a transaction.