Home > Error Code > Triton Atm Error Code 42

Triton Atm Error Code 42

Contents

Otherwise, replace the dispenser.Note, if this occurs on a Mini Mech, only during a multi note dispense, the exit sensors may have become weak. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 106 FIFO error The dispensing mechanism may have corrupt software. Purge the dispenser with the PURGE command. Ask an expert 1-800-259-6672 Service & Support Resources for ATM Products Need more info? this contact form

If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly. 3. Make sure that cable is connected at both ends. Attempting to operate the cash dispenser without the reject vault will normally cause it to go to an ìOut of Serviceî condition. Make sure the ribbon cable from the docking station to the card reader is fastened at both ends of the cable and the orientation of the cable is correct. 4.

Atm Error Codes List

Clear all errors and test the dispenser with a live transaction. Examine the timing wheel for physical defect. Once you have completed one of the above(more…) 152 Electronic journal corrupt 1.

Download to Triton Connect. Verify that main board to electronic journal and the electronic journal to dispenser cables securely seated at both ends of the cable. Restart ATM. Atm Error Codes 072 This error code indicates that the system has recognized a document intended for the reject vault has reached the note transport sensor.

Verify that there is only one of each type of cassette installed in the dispensing mechanism. 2. Triton Error Code 244 This Error Code is valid for units with SPED keypad device installed. If the problem persists; replace the dispenser. 36 24h) Mistracked note at exit Inspect the cassette and feed path for jammed notes. Read More Here Make sure the note diverter moves freely.

Choose Clear Journal. Mitsubishi Triton Error Codes Reset the cash dispenser and clear the error. If the error persists, replace the dispensing mechanism. The default bill size is $0.00 187 Maximum withdrawal not configured correctly This amount cannot be more than 50 times the bill size selected.

Triton Error Code 244

Inspect electronic journal to dispenser communication cable for damage. http://atmms.com/ Refer to error 500. 515 SPED device attention stuck. Atm Error Codes List Clean the exit sensor using a soft brush and a vacuum cleaner. Atm Error Code 3-da000(80) Replace dispenser if error code persists. 395 Multiple cassette of the same type.

Clear the error. 2. weblink If it is necessary to check continuity of the cable assembly, refer to Appendix B for pin out of the cable assembly. 3. If the cables are undamaged, the main board or electronic journal may be defective 156 Cassette out of service. Remove any unacceptable currency from the cassette. 2. Triton Error Code 151

Inspect electronic journal to dispenser communication cable for damage. belts; gears; cables; or sensors). Refill the cassette as needed. 2. http://u2commerce.com/error-code/triton-atm-error-code-148.html Refer to error 522. 527 EJ invalid request.

Clear all errors and test the dispenser by completing several test dispenses. Triton Error Code 139 Remove and refill the affected cassette using normal replenishment procedures. 303(33h)[3] Lifts are down. Enter management functions and verify that all terminal parameters have been entered correctly. 2.

Make sure that the exit sensor is clean and operation correctly. 3.

  • It the status clears; place the cash dispenser in service.
  • Verify that the diverter moves freely. 3.
  • If the power supply if operating normally; replace the note qualifier to correct the problem. 325(49h)[I] Note qualifier faulty Error code 325 is generated when the double detect sensors in the
  • Reset the Cash Dispenser by turning OFF the AC power switch for a few seconds and switching it back ON. 2.
  • Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 116 Motor Fault 1.
  • Make sure it is seated at the main board and at the printer control board at CN6. 5.
  • If the error clears; put the cash dispenser in service. 6.
  • Facebook Facebook LinkedInSearch Access © 2016: Access ATM, All Rights Reserved Access ATM, Inc.
  • a.
  • Verify the error code lights on the dispenser are operating in proper sequence.

Verify that all access panels are closed and secured. Inspect electronic journal to dispenser communication cable for damage. If the error persist, possible causes may be the modem or main board assembly. 193 Baud rate setting for electronic journal failed 1. Atm Error Code 3-da001 Restart the cash dispenser.

Clear terminal error code. If the cables are undamaged, the main board or electronic journal may be defective 166 Bad dispense 1. The system returned: (22) Invalid argument The remote host or network may be down. http://u2commerce.com/error-code/triton-atm-error-code-110.html Inspect the cable supplying DC power from the power supply to the printer.

Verify that the cable that connects the double detect module to the CMC module is undamaged and connected at both ends. Reset error code code. The cash dispenser will only be placed ìOut of Serviceî when all cassettes are empty. Verify that there is paper in the printer.

Check the computer area network connectors in the dispenser. Please try the request again.