Home > Error Code > Triton Atm Error Codes 151

Triton Atm Error Codes 151

Contents

Remove any jammed currency. 2. Restart operating system. Check the DC voltages supplied to the Printer. If it is necessary to check continuity of the cable assembly, refer to Appendix B for pin out of the cable assembly 5. http://u2commerce.com/error-code/triton-atm-error-codes-pdf.html

Inspect jumper block LK5 on the dispensers control board. a. Inspect main board to electronic journal communication cable for damage. The modem may be defective. 165 Electronic journal not present 1. my response

Triton Atm Error Code 148

Time-out waiting for response or carrier was dropped. Facebook Facebook LinkedInSearch Access © 2016: Access ATM, All Rights Reserved Access ATM, Inc. Replenish paper as needed. If the error persists, replace the SPED keypad module. 205 SPED keypad reported tamper condition Status valid only for units with SPED keypad device installed.

  1. If there is no visible damage and the connectors are attached to the sensor boards the best course of action is to replace the dispensing mechanism.
  2. If the currency is in “fit” condition and the error persists, consider replacing the cassette or the dispenser. 199 Dispense width errors This status appears when the count at the exit
  3. Seat connectors or replace the power supply as needed. 2.
  4. Open all access panels and inspect for jammed documents in note path between the note qualifier and note transport.

Clear the error. 5. Otherwise, replace the dispenser 37 Too long at exit. Inspect for jammed currency in the feed path and at the Exit sensor. Triton 9100 Error Code 148 Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 117 Timeout waiting for note to divert   118 Exit sensor blocked on start of dispense or

Make sure the connectors are seated securely on the main board and on the electronic journal. 4. Atm Error Codes List If the error does not occur again put the cash dispenser in service. Inspect for jammed currency in the transport path between the width sensors and the reject sensor. http://www.atmdepot.com/triton-atm-error-codes/ If these actions have no effect on dispenser operation, replace the dispenser mechanism.

Make sure the connectors are seated securely on the main board and on the electronic journal. 2. Atm Error Codes 072 Enter management functions menu and place the cassette(s) in service. 383 Dispense cassettes low (ALL). The transaction will be completed with the customersí receipt indicating the amount of cash actually received. Dispenser failed to identify the dispenser type installed.

Atm Error Codes List

Open the Security Cabinet and inspect the cash dispenser for broken parts. http://speedybuckatm.com/index.php/service-support/atm-error-codes Replenish the paper. Triton Atm Error Code 148 Used up all radial attempts and got No Dial Tone for each attempt. 2. Triton Error Code 244 Verify that all access panels are closed and secured. 3.

Restart the operating system. weblink Required fields are marked *Comment Name * Email * Website Math Captcha + 33 = 39 Recent Blog Posts 10 Reasons Cash Still King In an Increasingly Digital World 93% of Inspect electronic journal to dispenser communication cable for damage. Verify that there are no documents jammed in the note diverter area. Atm Error Code 3-da000(80)

Requested amount may exceed the dispensers one time limit. This error code is generated when a document from a note feeder fails to reach the note qualifier with in a specified time. If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5. navigate here If two or more of the same type cassette are installed; inject a new cassette ID into one of the cassettes that is different from the other cassette. 101 (65h) 2-second

Perform several test dispenses. Triton Error Code 139 Inspect the dispensing mechanism for of damaged components or broken wires. 2. If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5.

Perform a live transaction.

Test the dispenser by completing several test dispenses. Use the reject channel error code function to verify the operation of the sensors on the note transport module. Do several test dispense operations. 4. Triton Atm Error Code 101 If the error code continues; replace the note transport module.

PURGE the dispensing mechanism. This error code is returned by the dispenser when the number of notes in one or more of the cassettes is below a preset level; indicating the low level sensor in Inspect the dispensing mechanism for jammed currency at the diverter. his comment is here Verify that all DC voltages applied to the printer control board are correct.

Test the dispenser by completing several test dispenses. 4. This error code will place the cash dispenser in an ìOut of Serviceî condition. Inspect the feed path and feed sensors for jammed documents and broken components. If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly. 3.

Make sure the connectors are seated securely on the main board and on the electronic journal. 4.