Home > Error Code > Triton Atms Error Codes

Triton Atms Error Codes

Contents

Refer to Section 5 of the RL5000 Service Manual or the RL5000 Quick Reference Guide for instructions. 2. If the voltages are not within tolerance; you may need to replace the cable or power supply. Otherwise; it may be necessary to replace the dispenser. 4. Make sure that there is no foreign material in the card slot. http://u2commerce.com/error-code/triton-error-codes-135.html

Test the dispenser by completing several test dispenses. 4. Please try the request again. Purge the dispenser using the purge command. 3. Clean as needed with soft brush and vacuum cleaner. 2. my review here

Triton Error Code 244

Make sure the connectors are seated securely on the main board and on the electronic journal. 4. Inspect for jammed currency in the feed path and at the Exit sensor. The cables may be defective. 3.

  1. Inspect the cassette and feed path for notes that are stuck together or jammed.
  2. The dispenser will shut down, possibly resulting in trailing notes stopping in the path. 1.
  3. If the error persists; replace the SPED keypad module. 205 The SPED keypad reported a tamper condition Error code valid only for units with SPED keypad device installed.
  4. Inspect the Electronic Journal to make sure it is the correct part number.
  5. Reset the cash dispenser and clear the error.
  6. Verify that all DC voltages applied to the printer control board are correct.
  7. On all 8100/9100 machines, ensure the EJ data cable is connected to the lower RJ-45 data port on the 9100 main board.

If the problem persists; replace the dispenser. 50 (32h) Interference recovery Possible static discharge. The transaction will be completed with the customersí receipt indicating the amount of cash actually received. If error persists; replace the dispenser mechanism. 376 Dispenser multiple device error. Triton Error Code 139 If a cassette is not responding it may be necessary to inject a new identity into the cassette by completing the inject new cassette ID command.

Make sure the reject vault is installed correctly. Triton Error Code 151 Refer to error code 535. 556 System timeout. If the problem persists; replace the note transport module. 348(60h)[ë] Dispenser internal error. If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5.

If the error clears; put the cash dispenser in service. 4. Triton 9100 Error Code 148 Make sure that the ribbon cable from the docking station to the low paper sensor assembly is fastened at both ends of the cable and the orientation of the cable is when completing a cassette close function.) to keep it from filling up. Please try the request again.

Triton Error Code 151

Otherwise; replace the dispenser. 37 (25h) Note too long at exit Note was temporarily caught at exit. Test the dispensing mechanism by completing several Test Dispenses. 3. Triton Error Code 244 If error persists; replace the dispenser mechanism. 389 Dispenser offline. Atm Error Codes List Inspect all communication cables to make sure they are not damaged.

Test the dispenser by completing several test dispenses. weblink The cables may be defective. 3. Inspect all communication cables to make sure they are not damaged and are properly connect to their termination points. Inicia sesión para añadir este vídeo a una lista de reproducción. Mitsubishi Triton Error Codes

If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly. 3. Verify that all DC voltages applied to the printer control board are correct. This error code is produced when the single reject event counter exceeds 50 reject events or the bundle reject event counter exceeds 250 notes. http://u2commerce.com/error-code/triton-error-codes-144.html If the error persists, replace the dispensing mechanism.

gateway IP address, ports, etc.) 238 Dispenser Compromise A reset has occurred in the middle of a dispense. 1. Triton Atm Error Code 101 Verify that all DC voltages applied to the printer control board are correct. Additionally; the Triton Connect feature may be disabled at the cash dispenser.

Open the printer support bracket and verify that there are no jams in the printer or the paper path.

Inspect the cables connected to CN2, CN3, CN4, and CN5. See error code 557. 562 SPED error. If the error clears; put the cash dispenser in service. 5. Triton Error Code 246 The width sensor may be dirty.

Verify that all access panels are closed and secured. If the cables are undamaged, the main board or electronic journal may be defective 162 Electronic Journal get serial number failed 1. The maximum number of notes that can be dispensed from the dispenser during a transaction is defaulted to fifty. his comment is here On 96XX models, open the printer access latch and inspect for jams and blockage. 8. .