Home > Error Code > Triton Error Code 139

Triton Error Code 139

Contents

Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 122 Unexpected note at exit 1. If these actions have no effect on dispenser operation, replace the dispenser mechanism. Inspect the cassette and feed path for currency that is stuck together or jammed. 3. On all 8100/9100 machines, ensure the EJ data cable is connected to the lower RJ-45 data port on the 9100 main board. navigate here

Results: No money is dispensed, screen and receipt display system unavailable. Triton Connect error. Carrier was lost before receiving EOT. Otherwise, it may be necessary to replace the dispenser. 4. http://www.accessatm.com/service/atm-error-codes/triton-error-codes/

Triton Atm Error Code

Verify that the both ends of each cable are securely connected to its termination points. If the error persists, replace the SPED keypad module. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 124 Diverter moved to exit position during reject purge 1.

See Error Code 101, 302 or 306 B) Excessive rejects. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 105 Insufficient notes to learn from There may be an insufficient number of notes in the cassette Reset the error. Mitsubishi Triton Error Codes Inspect the note feeders and note qualifier for damage.

Test the dispensing mechanism by completing several test dispenses. Triton Error Code 244 Make sure they are seated at the printer control board and not damaged. 6. Verify that the cable that connects the double detect module to the CMC module is undamaged and connected at both ends. https://www.nasatm.com/error_codes/code/139/ The reject event counter can be reset by removing the reject vault from the dispenser and then putting it back into the dispenser.

Error Code: 101 (65h) Description: 2-second timeout waiting for pick. (Feed failure). Triton Atm Error Code 101 Reset the cash dispenser and clear the error. This is normally an internal terminal problem. Recommended Action: This error code is generated when there is a sensor error in one or more of the note feeders or when there is a document jammed in the note

  1. Enter the management functions and configure the multiple amount parameter.
  2. If these actions have no effect on dispenser operation, replace the dispenser mechanism.
  3. Recommended Action: Restart the operating system.
  4. EOT from processor was not received within time out period. 2.

Triton Error Code 244

Replenish paper as needed. http://chcatm.com/FAQ-pages/ATM-error-codes.htm Inspect for a currency jam at the diverter. 2. Triton Atm Error Code If the voltages are not within tolerance, the cable or power supply may be defective. 4. Triton Atm Error Code 33 Make sure the connectors are seated securely on the main board and on the electronic journal. 4.

If the error persist, possible causes may be the modem or main board assembly. 193 Baud rate setting for electronic journal failed 1. check over here Remove any documents blocking the throat opening. Recommended Action: See the recommended action for error code 144. If the error persists, replace the dispensing mechanism. Triton Error Code 151

Inspect the note diverter for proper operation and damage. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 104 Unable to clear width sensor. Recommended Action: Enter management functions and configure the maximum amount. http://u2commerce.com/error-code/triton-atm-error-code-148.html Your cache administrator is webmaster.

It is usually caused by attempting to dispense currency that is unacceptable or currency that has not been properly prepared. 1. Triton Error Code 246 If the cables are undamaged, the main board or electronic journal may be defective 149 Read from electronic journal failed 1. Verify the blue lever on the left side of the printer in the print position. 3.

Place all belts on their respective rollers and gears.

If these actions have no effect on dispenser operation, replace the dispenser mechanism. In addition National ATM Systems supplies ATM parts, ATM paper, ATM signage, processing, and communications. If these actions have no effect on dispenser operation, replace the dispenser mechanism. Triton 9100 Error Code 148 Error Code: 353(65h)[e] Description: No message to resend.

Purge the dispenser using the purge command. Inspect the feed path for jammed currency. If the error clears, put the cash dispenser in service. http://u2commerce.com/error-code/triton-atm-error-code-110.html Replace the dispenser is the error persists.

Verify that the power supply is operating and the DC voltages being supplied to the main board and dispenser are correct. Clear terminal error code. Allowable bill sizes are 5, 10, 20, 50, and 100. Test the TDM-100 by completing several Test Dispenses.

If the error clears, put the cash dispenser in service. 3. Install the cassette. Make sure the connectors are seated securely on the main board and on the electronic journal. 2. Make sure the connectors are seated securely on the main board and on the electronic journal. 2.