If these actions have no effect on dispenser operation, replace the dispenser mechanism. If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5. Inspect the dispensing mechanism for jammed currency at the diverter. Reset the cash dispenser by turning OFF the AC power switch for a few seconds and switching it back ON. this contact form
Error Code: 349(61h)[a] Description: Cassette lock faulty. Error Code: 122 (7Ah) Description: Unexpected note at exit 1. Recommended Action: This error code is returned by the dispenser when the number of notes in one or more of the cassettes is below a preset level, indicating the low level Reset the cash dispenser. http://www.atmexperts.com/atm_error_codes.html
Inspect electronic journal to dispenser communication cable for damage. Make sure that the exit sensor is clean and operation correctly. 3. Error Code: 153 Description: Electronic journal mode. Make sure the connectors are seated securely on the main board and on the electronic journal.
Error Code: 332(50h)[P] Description: Cassettes may have been changed. Carrier was lost before receiving EOT. Open all access panels and remove any jammed documents from the transport path. Atm Error Codes 072 Error Code: 149 Description: Read from electronic journal failed.
Retry the test operation and request fifty or fewer notes. Inspect for jammed currency at the Diverter. Clean and verify the operation of the exit sensor. Inspect the documents in each cassette to insure they are in fit condition.
This error is usually associated with “”unfit”” currency or an empty cassette. 1. Triton Atm Error Code 101 This is done to indicate that the power has been off. Clear the error. 3. Allowable bill sizes are 5, 10, 20, 50, and 100.
Inspect electronic journal to dispenser communication cable for damage. http://atmms.com/ Note, if the EJ is connected to the load port of the 9100 main board, permanent damage may result. 2. Atm Error Codes List Remove any jammed currency.2. Atm Error Code 3-da000(80) Recommended Action: Restart the operating system.
Access the error code command to determine if any sensors in the reject channel are dirty of defective. weblink Error Code: 148 Description: Write to electronic journal failed. Remove the cassette and inspect for jammed currency in the width sensor and at the output of the cassette. Error Code: 56 (38h) Description: Link error Recommended Action: 1. Triton Error Code 151
The exit sensor may be dirty. Error Code: 36 (24h) Description: Mistracked note at exit. Recommended Action: This error code is generated when a cassette is emptied during a dispense operation and does a partial dispense. http://u2commerce.com/error-code/triton-atm-error-code-148.html Carefully remove the double detect module from the note qualifier.
Reset the Cash Dispenser by turning OFF the AC power switch for a few seconds and switching it back ON. Triton Error Code 139 Purge the dispenser using the purge command. If the sensor is not operating normally, replace the note transport module.
Remove each note feeder module from the dispensing mechanism and clean their associated empty, pressure and exit sensors with clean compressed air. If the status clears and the return code are normal place the cash dispenser in service. Error Code: 206 Description: SPED keypad could not perform a successful command within SPED MAX_ATTEMPTS tries. Mitsubishi Triton Error Codes If the error clears, put the cash dispenser in service. 6.
Inspect the dispenser to make sure all belts are on track and in good physical condition. Inspect the note diverter in the note transport module. If the error persists, replace the dispensing mechanism. http://u2commerce.com/error-code/triton-atm-error-code-110.html If these actions have no effect on dispenser operation, replace the dispenser mechanism.
This is a Triton Connect error. 1. If the error persists, replace the SPED keypad module. 206 SPED keypad could not perform a successful command within SPED_MAX_ATTEM PTS tries Status valid only for units with SPED keypad device Inspected both the feed sensor and the double detect sensor to ensure they are not blocked and operating correctly. Check local telephone line for proper operation. 3.
Make sure the connectors are seated securely on the main board and on the electronic journal. 2. The journal on these machines should be printed on a regular basis (i.e. Recommended Action: This error code is reported when an internal error occurs in the dispenser. Do several test dispense operations. 3.
Complete several Test Dispenses to verify correct operation. 3. If the error does not show again put the cash dispenser into service. Make sure that the cassettes are installed and locked before performing a test dispense or live transaction. Replace the power supply or dispenser DC power if either is defective. 3.
Remove the jammed documents as needed. If the error persists, replace the card reader. Purge the dispenser using the purge command. Recommended Action: Reset the cash dispenser by turning OFF the AC power switch for a few seconds and switching it back ON.
Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 112 Timeout waiting for leading edge at reject A note that was expected to be seen at