Home > Error Code > Triton Error Code 339

Triton Error Code 339

Contents

Access the management function diagnostics menus to verify the operational error code of dispenser mechanism sensors. Inspect for jammed currency in the feed path and at the Exit sensor. If the error clears; put the cash dispenser in service. 5. Make sure the connectors are seated securely on the main board and on the electronic journal. 4. this contact form

Replace the power supply or dispenser DC power if either is defective. 3. Inspect the feed path for currency that is stuck together or jammed. The journal on these machines should be printed on a regular basis (i.e. All cassettes report no notes. find more info

Triton Atm Error Codes

If the error reoccurs the most likely causes of the problem may be note transport or CMC. 305(35h)[5] Diverter Failure. Clear terminal error code. If injecting a new cassette ID into the cassette does not correct the problem; replace the cassette. 322(46h)[F] Main motor failure Error code 322 is generated when the main motor fails Complete several live dispenses to ensure the dispenser is working correctly.

  • If this does not correct the problem, verify that the paper low sensor is correctly attached to the paper bracket and that the cable between the paper low paper feed assembly
  • Purge the dispenser using PURGE command.
  • Make sure the connectors are seated securely on the main board and on the electronic journal. 2.
  • Make sure the connectors are seated securely on the main board and on the electronic journal. 4.
  • Inspect the dispenser power cable; the Backplane-to-Electronic Journal cable; and the Electronic Journal-to-dispenser cable to ensure each is securely seated at both ends and not damaged.
  • Reset the cash dispenser.
  • Clear any jammed currency. 2.

This error code will cause the cash dispenser to go ìOut of Serviceî. Possible may be a processor or telephone hardware problem (If problem persists call Your Service Provider or Triton Tech Support) 5 Connect 1200 Baud then lost carrier or connection. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 107 Time out waiting for FIFO The dispenser is reporting the leading note has not cleared the Triton Error Code 101 If these actions have no effect, replace the dispenser. 44 Bad Roller Profile This status is generated if the double detect is unable to calibrate.

C:\Documents and Settings\Administrator>RegCure Pro.exe Windows Triton Error Code 339 may caused by some of the following errors Windows Explorer ErrorsJavascript ErrorsHardware MalfunctionError Symptom include:Can not printing fileBlue ScreenIO errorShutdown problemsHttp error Triton Atm Error Code 33 A normal return code for this test dispense operation is ì4 1 1 1 1? This error code is generated by the dispensing mechanism when the calibration value for at least one of the sensors in any of the note feeders has exceeded the upper limits Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 111 Diverter timeout Inspect for jammed currency at the diverter.

Purge the dispenser using the purge command. Triton Error Code 236 If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5. Complete several Test Dispenses to verify correct operation. The cables may be defective. 3.

Triton Atm Error Code 33

If the error persists; replace the dispenser. 46 (2Eh) Exit quantified A mechanical failure has occurred. Inspect electronic journal to dispenser communication cable for damage. Triton Atm Error Codes If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly. 3. Triton Error Code 244 Test the dispensing mechanism by completing several Test Dispenses. 3.

If these actions have no effect on dispenser operation, replace the dispenser mechanism. weblink Verify that each cassette is placed in its designated feed channel. Remove the cassette and visually inspect for loose or disconnected connectors on both the upper and lower width sensor printed circuit boards. 3. Remove jammed currency. 2. Triton Atm Error Code 151

Refer to error 500. 513 SPED device offline. It the error code repeats; verify the power supply output voltages are within expected values. Reset the cash dispenser and clear the error. http://u2commerce.com/error-code/triton-atm-error-code-148.html If the cable ends are seated properly and there is no apparent damage to the cable; it will be necessary to verify the continuity of each cable; otherwise replace the dispenser.

Restart the cash dispenser. Triton Traverse Error Code 917 If the cables are undamaged, the main board or electronic journal may be defective 146 No reply from command to electronic journal 1. The Triton Connect Host Computer generates this error when a terminal does not make a call to the Triton Connect Host Computer as requested.

The Triton Connect Host Computer generates the error when a terminal does not respond to a telephone call from the Triton Connect Host Computer.

If cash dispenser operates normally when performing the test dispense function; put the cash dispenser in service. Verify the physical presence of each cassette. The maximum number of notes that can be dispensed from the dispenser during a transaction is defaulted to fifty. Triton Error 563 Once they are displayed on the screen, print or save them to an external device.

If the voltages are correct, and the cables are undamaged and correctly connected, causes of this error may be a defective cable, a defective printer, printer control board or the main If the error does not occur again; put the cash dispenser in service. 4. The dispenser sends this status code when a command has been successfully executed. http://u2commerce.com/error-code/triton-atm-error-code-110.html Verify the blue lever on the left side of the printer in the print position. 2.

Inspect main board to electronic journal communication cable for damage. Make sure that there is no foreign material in the card slot. 2. NOTE: If the download link doesn't work you may need to Download it Directly from a Mirror Here. Verify the quality of your incoming TCP-IP connection and your TCP-IP configuration.

Inspect card reader for foreign objects. Verify the error code lights on the dispenser are operating in proper sequence. This error may occur anytime that a cassette is removed from the cash dispenser with the AC Power ON. Replace the dispensing mechanism. 56 Link error 1.

a. If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5. Change baud rate settings. 4. Verify that main board to electronic journal and the electronic journal to dispenser cables securely seated at both ends of the cable.