Home > Error Code > Triton Error Code 621

Triton Error Code 621

Contents

Reset the dispenser and try to complete a test dispense. Inspect electronic journal to dispenser communication cable for damage. Then it will complete the test dispense function. Clean the sensors in the note transport a needed. navigate here

Remove any jammed currency. 2. What causes Triton Error Code 621 error? Inspect for jammed currency in the feed path and at the Exit sensor. If error code re-occurs; disable low paper checking and place the terminal back into operation.

Triton 9100 Error Codes

If the cables are undamaged, the main board or electronic journal may be defective 146 No reply from command to electronic journal 1. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 106 FIFO error The dispensing mechanism may have corrupt software. When the note is stuck in between the note transport sensor and the throat.

  1. If EOT is received on subsequent attempts; then Error Code 1 is reported. (If problem persists call Your Service Provider or Triton Tech Support). 15 Timed out waiting for EOT See
  2. Install the cassette.
  3. Inspect main board to electronic journal communication cable for damage.
  4. Purge the dispenser with the purge command under diagnostics.
  5. This error code will be generated when the following conditions occur: 1.
  6. If the diverter has excessive binding or appears damaged; replace the dispenser. 2.
  7. If the error persists, possible causes of the problem may be the low paper sensor assembly, the docking station, the main board, or cables. 196 Card reader error 1.
  8. Inspect all communication cables to make sure they are not damaged and are properly connect to their termination points.

The cables may be defective. 3. If the sensor is blocked; remove the blockage. If the currency is in “fit” condition and the error persists, consider replacing the cassette or the dispenser. 199 Dispense width errors This status appears when the count at the exit Triton Traverse Error Code 917 Make sure the connectors are seated securely on the main board and on the electronic journal. 2.

If the error clears, put the cash dispenser in service. Triton Error Code 244 If the currency is in “fit” condition and the error persists, consider replacing the cassette or the dispenser. 34 Mis tracked note at double detect.   35 Mistracked note at exit. If the cables are undamaged, the main board or electronic journal may be defective 163 Terminal did not answer. Refer to error code 535. 546 Card Reader ñ No data.

Purge the dispenser using the purge command. Triton Error Code 101 Restart the operating system. Refer to error code 535. 552 Card Reader ñ Device received invalid request. Replace the dispensing mechanism. 54 Operation time-out 1.

Triton Error Code 244

When troubleshooting the 8100, 9100, RL and RT be aware that the electronic journal is built into the main board of the dispenser. http://triton.error.code.621.winwizards.org/ Inspect for a currency jam at the diverter. 2. Triton 9100 Error Codes Clear the error. Triton Atm Error Code 151 Restart the operating system.

Verify that the diverter moves freely and is not binding. check over here Replace the dispenser is the error persists. 358 Dispenser device read error. Test the dispenser by completing several test dispenses. 3. If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly. 3. Triton Atm Error Code 33

No money is dispensed; screen and receipt display system unavailable. (If problem persists call Your Service Provider or Triton Systems Technical Support) 3 BGD_NOANSWER No money is dispensed; screen and receipt If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5. Clear all errors and test the dispenser by completing several test dispenses. http://u2commerce.com/error-code/triton-atm-error-code-148.html Verify operation of the power supply.

If the problem persists, replace the dispensing mechanism 100 Good operation No Action Necessary. Triton 9100 Error Code 148 Clear all errors and test the dispenser by completing several TEST DISPENSES. This is most often caused by slipping stacker pulleys. 1.

Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 104 Unable to clear width sensor.

Make sure the connectors are seated securely on the main board and on the electronic journal. 2. If the error persists; possible causes of the problem may be the low paper sensor assembly; the docking station; the main board; or cables. Inspect electronic journal to dispenser communication cable for damage. Triton Error Code 236 On 32-bit machines (RL’s, FT’s, RT’s) the electronic journal can store as many as 32,768 records, it is recommended that you do not print the journal.

Verify that all DC voltages applied to the printer control board are correct. This status is reported if the exit sensor is covered for a longer that allowed time for the current notes.1 Inspect the note transport and delivery throat make sure all belts Put the cassettes back into its feed channel. http://u2commerce.com/error-code/triton-atm-error-code-110.html Inspect the dispensing mechanism for jammed currency at the exit sensor.

This error will not put the cash dispenser ìOut of Serviceî. Replace the timing wheel or the timing wheel sensors if they are defective. Remove any documents from the tote transport. Enter management functions and configure the maximum amount. 188 Communications key not configured Enter management functions and configure the communications key either manually or by download (depending on the processor). 189

This status is generated when there are 8 rejects during the current dispense. Additionally; the Triton Connect feature may be disabled at the cash dispenser. If error fails to reset, or the error reoccurs in a short amount of time, consider replacing the SPED. 241 SPED Warning: Self Test error See Error Code 240 382 Dispenser If the error does not occur again put the cash dispenser in service.

Note, if the EJ is connected to the load port of the 9100 main board, permanent damage may result. 2. This status code will appear in the electronic journal as code 32 indicating the successful completion of a transaction. 33 Feed Failure This error is usually associated with an empty note If it is necessary to check continuity of the cable assembly, refer to Appendix B for pin out of the cable assembly. 3. An operating system timeout has occurred.

This code is used by the vendor to identify the error caused. Install the cassette. Restart the operating system. This error code is generated when there is a sensor error in one or more of the note feeders or when there is a document jammed in the note feeder exit

Turn the AC power OFF for a few seconds and then back ON to power cycle and reset the cash dispenser. 3. Otherwise, replace the dispensing mechanism. Ensure there is currency in the cassette. Purge the dispenser with the purge command under diagnostics.

Refill the cassette as needed. 2.