Home > Error Code > Triton Error Codes 148

Triton Error Codes 148

Contents

It the status clears, place the cash dispenser in service. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 111 Diverter timeout Inspect for jammed currency at the diverter. Purge the dispenser. If the error does not repeat again; complete a live dispense to verify the note diverter moves the currency to the exit position. http://u2commerce.com/error-code/triton-atm-error-codes-pdf.html

If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly. 3. Additionally; the Triton Connect feature may be disabled at the cash dispenser. Reset the cash dispenser and clear the error. If the problem persists; replace the dispenser. http://www.accessatm.com/service/atm-error-codes/triton-error-codes/

Triton Error Code 244

Make sure all cables are properly connected. Make sure that the access panels before and after the diverter are closed and secured in place. Clear the error. The cables may be defective. 3.

Install a new roll of paper if needed. 2. Otherwise; replace the dispenser. 38 (26h) Blocked Exit Exit sensor blocked or open circuit. Examine the timing wheel for physical defect. Mitsubishi Triton Error Codes Clean the sensors in the note transport a needed.

Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 107 Time out waiting for FIFO The dispenser is reporting the leading note has not cleared the Seat connectors or replace the power supply as needed. 2. If the error clears; put the cash dispenser in service. 4. https://www.tritonatm.com/service_and_support/error_code_lookup/index.php If the error clears put the Cash Dispenser into service.

Verify that there is paper in the printer. Triton Traverse Error Code 917 Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 103 Thickness sensor unstable Enter the diagnostic function and complete the “learn note thickness” command. Reseat connectors or replace the power supply as needed. 2. Make sure there are not any documents jammed at any of note feeder exit sensors.

Triton Error Code 151

Clear terminal error code. http://www.jarrettforcash.com/trbl_triton9100.html Replenish paper as needed. Triton Error Code 244 Clear the error. Atm Error Codes List Refer to error 500. 509 SPED no data.

Inspect electronic journal to dispenser communication cable for damage. check over here Learn More MERCHANT SERVICES ATM Merchant Systems offers a full line of credit card terminals and merchant account services to meet your processing needs. The maximum withdrawal cannot exceed 50 time the denomination of the bill size in the cassette. 188 PIN working key not configured Enter the management functions and configure (download) the working Purge the dispenser using PURGE command. Triton Atm Error Code 101

  • Inspect main board to electronic journal communication cable for damage.
  • If the error clears, put the cash dispenser in service. 5.
  • Replace the exit sensor if necessary.4.
  • Verify the blue lever on the left side of the printer in the print position.
  • If the voltages are not within tolerance, the cable or power supply may be defective. 4.
  • Host hung up.
  • Check the calibration value for the pressure; empty; and exit sensors.

Make sure the connectors are seated securely on the main board and on the electronic journal. 4. Restart ATM. The hoppers are not detected. his comment is here Clear terminal error code.

Close ATM control panel. Triton 9100 Error Code 148 If the test dispenses are completed normally, and the return code are correct, clear all errors and place the cash dispenser in operation.b. If the error does not occur again put the cash dispenser in service.

Reset the cash dispenser and clear the error.

Perform a live transaction. Complete several live dispenses to ensure the dispenser is working correctly. Make sure the connectors are seated securely on the main board and on the electronic journal. 2. Triton Error Code 246 Verify that the diverter moves freely.

Inspect electronic journal to dispenser communication cable for damage. Press the power switch off, wait 10 seconds, then turn back on. Error code 320 will not put the cash dispenser ìOut of Service. weblink If the cable ends are seated properly and there is no apparent damage to the cable; it will be necessary to verify the continuity of each cable; otherwise replace the dispenser.

Otherwise; replace the dispenser. 37 (25h) Note too long at exit Note was temporarily caught at exit. Make sure the connectors are seated securely on the main board and on the electronic journal. Clear the error. 2. If a cassette is not responding it may be necessary to inject a new identity into the cassette by completing the inject new cassette ID command.

This status code will appear in the electronic journal as code 32 or 100 indicating the successful completion of a transaction. 101 2-second timeout waiting for pick. (Feed failure). Input the number of enties you want printed. Refer to error 522. 531 EJ SOH error. Reset the error code.

Refer to the appropriate Service Manual or Quick Reference Guide for instructions. 2. If error returns, call us for service. Refer to error code 535. 553 Card Reader ñ device offline. Replace the exit sensor if defective.

Enter management functions and verify that all terminal parameters have been entered correctly. 2. Inspect the cassette and feed path for currency that is stuck together or jammed. 2. If the error clears put the Cash Dispenser into service. Perform "Receipt Printer Test." If error does not return, place ATM back in service.

Turn the AC power OFF for a few seconds and then back ON to power cycle and reset the cash dispenser. 3. Verify the blue lever on the left side of the printer in the print position. 3.