Home > Error Code > Triton Error Codes 151

Triton Error Codes 151

Contents

Suspect the main board, the TCP-IP connection device (Quad Port Board in 96XX, Docking board on RL, FT or RT) or the TCP-IP equipment. 237 TCP/IP device failed Out going commutations Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 105 Insufficient notes to learn from There may be an insufficient number of notes in the cassette View Unaudited Records. If no jams are found, remove the note closest the pick rollers in the cassette. 3. http://u2commerce.com/error-code/triton-atm-error-codes-pdf.html

If the cash dispenser operates normally put it in service. Inspect electronic journal to dispenser communication cable for damage. If these actions have no effect, replace the dispenser. 44 Bad Roller Profile This status is generated if the double detect is unable to calibrate. Recommended Action: Restart the operating system. http://www.accessatm.com/service/atm-error-codes/triton-error-codes/

Triton Atm Error Code 148

Verify that the both ends of each cable are securely connected to its termination points. The cash dispenser will then attempt to complete a Reversal Transaction to notify the financial institution of the error. Allowable bill sizes are 5, 10, 20, 50, and 100. If the error persists, possible causes of the problem may be the low paper sensor assembly, the docking station, the main board, or cables. 196 Card reader error 1.

Either the VEPP was changed or the software was reloaded, such as when you do a VEPP upgrade, or if the VEPP was changed. 2. Recommended Action: See the recommended action for error code 144. Clean as needed with soft brush and vacuum cleaner. 2. Triton Atm Error Code 101 Host hung up.

The reason that the error code is generated is the detection of an incorrect LRC character or a parity error. If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly. 3. Recommended Action: See the recommended action for error code 144. https://www.nasatm.com/error_codes/code/151/ If the sensor is not operating normally, replace the note transport module.

If the error does not repeat again, complete a live dispense to verify the note diverter moves the currency to the exit position. Triton Error Code 139 Error Code: 320(44h)[D] Description: Reject cassette almost full. Clear terminal error code. Install a new roll of paper if needed. 2.

Triton Atm Error Code 245

If the voltages are correct, and the cables are undamaged and correctly connected, causes of this error may be a defective cable, a defective printer, printer control board, or the main Inspect the cable supplying DC power from the power supply to the printer. Triton Atm Error Code 148 Test the dispenser by completing several test dispenses. 5. Atm Error Codes List If these actions have no effect, replace the dispenser.

Recommended Action: See the recommended action for error eode 128. weblink Inspect main board to electronic journal communication cable for damage. If replacing the modem does not correct the problem, replace the main board. Remove any jammed currency.2. Triton 9100 Error Code 148

Verify clearance at the diverter. When the note is stuck in between the note transport sensor and the throat. Clean as needed with compressed air. navigate here Clear terminal error code.

Error Code: 147 Description: Error in reply from electronic journal. Triton Traverse Error Code 917 If the requested amount cannot be dispensed, the customer will receive the cash that can be dispensed. Purge the dispensing mechanism with the PURGE command from the DIAGNOSTICS function.

If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly 5.

  1. Verify that the cable that connects the double detect module to the CMC module is undamaged and connected at both ends.
  2. Recommended Action: This error code will occur only in cash dispensers running ACS terminal software.
  3. If the error clears, put the cash dispenser in service. 3.

Clear the error. Purge the dispenser using the purge command. Make sure all ports on your gateway (connecting router) are open for bidirectional comms. 3. Triton Error Code 246 Clear all error and purge the dispenser using the purge command. 3.

Clear terminal error code. If the error reoccurs the most likely causes of the problem may be note transport or CMC. Inspect for jammed currency in the feed path and at the Exit sensor. his comment is here If these check are not properly completed replace the note qualifier.

If the error clears, put the cash dispenser in service. 3. Clear all errors and test the dispenser by completing several test dispenses. Make sure the note diverter moves freely.