Home > Error Code > Triton Error Codes 205

Triton Error Codes 205

Contents

Clean and verify the operation of the exit sensor. for a four cassette dispenser. Once they are displayed on the screen, print or save them to an external device. Purge the dispenser with the purge command under diagnostics. http://u2commerce.com/error-code/triton-atm-error-codes-pdf.html

Refer to error 522. 529 EJ device offline. Clean the dirty sensor; or replace the note transport as needed. Access the error code command to determine if any sensors in the reject channel are dirty of defective. Refer to error 522. 528 EJ sequence error.

Atm Error Codes List

If the test dispenses pass, but the error returns upon live dispenses, do dispenses with the vault door open. If the error persists; replace the SPED keypad module. 206 SPED could not perform a successful command within SPED_MAX_ATTEMPTS tries Error code valid only for units with SPED keypad device installed. If these check are not properly completed replace the note qualifier. 326(4Ah)[J] Note feed sensor failure.

  • Reload cassettes.
  • Turn the AC power OFF for a few seconds and then back ON to power cycle and reset the cash dispenser.
  • Purge the dispenser with the purge command. 3.
  • The exit sensor may be dirty.
  • Make sure the connectors are seated securely on the main board and on the electronic journal. 2.
  • Test the dispensing mechanism by completing several test dispenses. 4.
  • The Triton Connect Host Computer generates this error when a terminal does not make a call to the Triton Connect Host Computer as requested.
  • It the error clears put the cash dispenser back in service.
  • The reject event counter can be reset by removing the reject vault from the dispenser and then putting it back into the dispenser. 321(45h)[E] Cassette data corrupted.

The Triton Connect Host Computer generates the error when the terminal does not respond to a telephone call from the Triton Connect Host Computer. 2. Make sure they are seated at the printer control board and not damaged. 6. Reset the cash dispenser. Atm Error Codes 072 Release the printer locking screw.

This status code will appear in the electronic journal as code 32 or 100 indicating the successful completion of a transaction. 101 2-second timeout waiting for pick. (Feed failure). Triton Error Code 244 Clear the error. Then it will go “out of service”” for and error code 195 “out of paper”. 185 Telephone number not configured Enter Management Functions and configure the telephone number. 186 Bill Size https://www.tritonatm.com/service_and_support/error_code_lookup/index.php is a registered ISO of MetaBank, Storm Lake IA 50588 Shopping Cart Home (888) 225-9184 Call Today!

Test the TDM-100 by completing several Test Dispenses. Mitsubishi Triton Error Codes Verify that main board to electronic journal and the electronic journal to dispenser cables securely seated at both ends of the cable. Make sure the connectors are seated securely on the main board and on the electronic journal. 2. Remove all documents from the reject vault.

Triton Error Code 244

Refill the cassette as needed. 2. http://atmms.com/ Verify that all DC voltages applied to the printer control board are correct. Atm Error Codes List Refer to error 500. 506 SPED invalid request. Triton Error Code 151 Make sure the connectors are seated securely on the main board and on the electronic journal. 2.

Purge the dispenser using the purge command. check over here Remove any jammed notes.2. Restart the cash dispenser. If the voltages are not within tolerance, the cable or power supply may be defective. 4. Atm Error Code 3-da000(80)

Otherwise, it may be necessary to replace the dispenser.4. Test the dispenser by completing several test dispenses. 3. Baud rate set to high for telephone line conditions. his comment is here Refer to error code 535. 544 Card Reader ñ Invalid request.

If the error clears, put the cash dispenser in service. 5. Triton Error Code 139 Clear terminal error code. Remove the cassette and visually inspect for loose or disconnected connectors on both the upper and lower width sensor printed circuit boards. 3.

If the error recurs; a faulty cassette; note feeder or CMC module may be cause the problem. 305(35h)[5] Diverter Failure.

Replace the dispenser if the error persists. 182 Currency Cassette low This condition will occur before the Cassette is actually empty. Restart the cash dispenser. Cracked or broken clips should be replaced 4. Triton Atm Error Code 101 If error persists; replace the main board assembly. 557 System device reset.

Remove the cassette and inspect for jammed currency in the width sensor and at the output of the cassette. Inspect the note transport sensor for blockage. If these actions have no effect, replace the dispenser. 44 Bad Roller Profile This status is generated if the double detect is unable to calibrate. weblink Purge the dispenser with the purge command.

Complete several live dispenses to ensure the dispenser is working correctly. Reset the cash dispenser. Remove any jammed currency. 2. Inspect the documents in each cassette to insure they are in fit condition.

Purge the dispenser using the purge command. 3. If the error code recurs; replace the CMC module. 356(68)[h] Error in note transport. Reset the dispenser and try to complete a test dispense. Search parts by scanning barcodes with your Android $0.00 Live Help Desk Menu Products Nautilus Hyosung ATM Machines Halo II 2700CE 2700T 5200 4000W Genmega ATM Machines G2500 Onyx Onyx W

Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 115 Diverter timeout on purge 1. Refill the cassette as needed. 2. Purge the dispenser using the purge command from diagnostic menu. 2. This error code indicates that the system has recognized a document intended for the reject vault has reached the note transport sensor.