Home > Error Code > Triton Error

Triton Error

Contents

Clear terminal error code. Inspect electronic journal to dispenser communication cable for damage. Verify that the diverter moves freely and is not binding. Test the dispenser by completing several test dispenses. 5. this contact form

It is usually caused by attempting to dispense currency that is unacceptable or currency that has not been properly prepared. 1. atmsofny 3,546 views 1:50 Orwellian Biometric ATM machines - Duration: 4:49. If the status clears and the return code are normal place the cash dispenser in service. Verify that all sensors are operation correctly. read this article

Triton Error Code 244

Restart the cash dispenser. Test the dispensing mechanism by completing several test dispenses. Verify that all access panels are closed and secured. 3. Refer to error code 535. 553 Card Reader ñ device offline.

Check the calibration value for the pressure; empty; and exit sensors. Purge the dispenser using the purge command. Refer to error code 535. 556 System timeout. Mitsubishi Triton Error Codes Make sure they are seated at the printer control board and not damaged. 6.

Clear as necessary and perform both printer diagnostic tests as outlined in Recommended Actions for Error Code 138 142 Dispenser returns bad command error The most likely cause of this error Restart the cash dispenser. If injecting a new cassette ID into the cassette does not correct the problem; replace the cassette. 322(46h)[F] Main motor failure Error code 322 is generated when the main motor fails Clear terminal error code.

Sign in to add this to Watch Later Add to Loading playlists... Triton Error Code 139 Verify that the diverter moves freely. 3. Verify that the power supply is operating and the DC voltages being supplied to the main board and dispenser are correct. Test the dispenser by completing several test dispenses. 4.

  1. This status code will appear in the electronic journal as code 32 or 100 indicating the successful completion of a transaction. 101 2-second timeout waiting for pick. (Feed failure).
  2. To prevent this occurence: 1.) Remove the cassette from the dispenser 2.) Press the RESET ERROR key. 3.) Refill the cassette and install it in the dispenser 34 (22h) Mistracked note
  3. If the cables are undamaged, the main board or electronic journal may be defective 166 Bad dispense 1.
  4. Reset the cash dispenser.
  5. Check for and clear any foreign debris the note path.
  6. If these check are not properly completed replace the note qualifier. 326(4Ah)[J] Note feed sensor failure.
  7. Morra 392 views 3:00 2003 Ford F150 5.4 liter Triton Spark Plug removal and install - do it yourself and save some cash - Duration: 13:30.
  8. Refilling may be delayed for several transactions if the error code is the first warning that the cassette is nearly empty.

Triton 9100 Error Codes

If the operation is normal; you may put the cash dispenser in service. pop over to these guys If this does not correct the problem, verify that the paper low sensor is correctly attached to the paper bracket and that the cable between the paper low paper feed assembly Triton Error Code 244 PURGE the dispensing mechanism. Atm Error Codes List This is a Triton Connect error.

Inspect electronic journal to dispenser communication cable for damage. weblink If it is necessary to check continuity of the cable assembly, refer to the appropriate ATM Service Manual for pin out of the cable assembly. 3. Clear terminal error code. Remove the cassette and inspect for jammed currency in the width sensor and at the output of the cassette. Triton Error Code 151

Inspect the Electronic Journal to make sure it is the correct part number. Inspect the feed path for any jammed notes. This error code is generated when the note transport sensor does not detect a note that was detected by the note qualifier. navigate here Reset the cash dispenser.

Check the operation of all sensors in the note transport module. Triton Atm Error Code 101 Inspect the feed path for jammed notes. If the error clears put the Cash Dispenser into service.

Verify that all access panels are closed and secured.

Test the dispenser by completing several test dispenses. Check the incoming power and dispenser mechanism for proper grounding.2. The most probable cause is either mechanical or electrical failure of the note diverter in the note transport module. Triton Traverse Error Code 917 Other components that may cause this error are the main board or the dispensing mechanism. 134 Exit blocked as reported by status check 1.

If these actions have no effect, replace the dispensing mechanism. 203 SPED keypad is not replying to main board Status valid only for units with SPED keypad device installed. 1. The exit sensor may be dirty. Purge the dispenser with the purge command. his comment is here Inspect the currency for excessive wear.

Make sure the connectors are seated securely on the main board and on the electronic journal. 4. Purge the dispenser using the purge command. If the status clears and the return code are normal place the cash dispenser in service. Clear the jammed documents. 2.

Clear all error and purge the dispenser using the purge command.4. Complete several test dispenses to verify correct operation. If the error persists, replace the SPED keypad module. 206 SPED keypad could not perform a successful command within SPED_MAX_ATTEM PTS tries Status valid only for units with SPED keypad device Inspect main board to electronic journal (EJ) communication cable for damage.

At least one character was received (ETX was never received). If it is necessary to check continuity of the cable assembly,refer to the appropriate ATM Service Manual for pin out of the cable assembly 5. Inspect the detent clips (the clips that hold the cassette in place). Clean the width sensor with compressed air.

Loading... Access management functions and enable cassettes. 367 Dispenser communication error. Turn the AC power OFF for a few seconds and then back on to power cycle and reset the cash dispenser. Otherwise; it may be necessary to replace the dispenser. 4.

If the test dispenses pass, but the error returns upon live dispenses, do dispenses with the vault door open. Inspect the exit area to ensure nothing is blocking the exit sensor. Check with the processor. 144 No reply from the Electronic Journal Inspect cable to ensure it is securely attached to the Backplane at J4 and at the Electronic Journal. Inspect for jammed currency at the diverter.

Otherwise, replace the dispenser.2. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 115 Diverter timeout on purge 1.