Home > Error Code > Triton Rl1600 Error Codes

Triton Rl1600 Error Codes

Contents

Verify that all access panels are closed and secured. Other components that may cause this error are the main board or the dispensing mechanism. 132 Status reports bad double detect in last dispense 1. Reset the cash dispenser and clear the error. Make sure the connectors are seated securely on the main board and on the electronic journal. 2. http://u2commerce.com/error-code/triton-atm-error-codes-pdf.html

Replace cassette or Inject New Cassette ID. 500 SPED Read Error. Clear terminal error code. Test the TDM-100 by completing several Test Dispenses. Enter management functions and configure the maximum amount. 188 Communications key not configured Enter management functions and configure the communications key either manually or by download (depending on the processor). 189 click to read more

Triton Atm Error Codes

Replace SPED battery is below 2.8 VDC. All cassettes have reached low cash level. Inspect the note transport make sure all belts are on track and there is no currency jammed in the transport or exit areas. Inspect the cassette and feed path for currency that is stuck together or jammed. 2.

Reset the Cash Dispenser by turning OFF the AC power switch for a few seconds and switching it back ON. The hoppers are not detected. If the error clears; put the cash dispenser in service. 3. Triton Traverse Error Code 917 This problem may be caused by incompatibilities between terminal software and dispensing mechanism software.

If the problem persists; replace the dispenser. 49 (31h) Jam at exit Inspect the feed path for jammed notes. Verify that there is only one of each type of cassette installed in the dispensing mechanism. 2. Remove jammed currency. 2. Replace the cassette. 2.

Make sure it is seated at the main board at J15 and at the printer control board at CN6. Triton Atm Error Code 101 Make sure the connectors are seated securely on the main board and on the electronic journal. Verify that the diverter moves freely. 3. If error persists; replace the dispenser mechanism. 371 Dispenser SDD com error header-trailer.

Triton Error Code 244

Home ATM Machines Genmega Onyx Series Onyx W Series G2500 Series GT3000 Series GK1000 Bill Payment G6000 Series Hantle 1700W Series C4000 Series T4000 Series Coin Goat Series Hyosung Halo II Change baud rate settings. 4. Triton Atm Error Codes Restart the cash dispenser and reset the error. Triton Atm Error Code 151 Verify power is applied to the dispenser. 386 Dispenser offline ñ no hoppers.

Verify the blue lever on the left side of the printer in the print position. weblink Put more currency in the cassette and repeat the ìlearn note thicknessî command. 106 (6Ah) FIFO error The dispensing mechanism may have corrupt software. If the cables are undamaged, the main board or electronic journal may be defective 159 Electronic journal test feature failed 1. Restart the operating system. Atm Error Codes List

If the error does not show again put the cash dispenser back into service. If the error code is reported again; replace the CMC module. Refer to error 522. 525 EJ invalid ID. navigate here This error code is generated when the note transport sensor does not detect a note that was detected by the note qualifier.

Use a soft brush abd vacuum cleaner to clean the exit sensor. 4. Triton Error Code 139 On 32-bit machines (RL’s, FT’s, RT’s) the electronic journal can store as many as 32,768 records, it is recommended that you do not print the journal. Clear all errors and test the dispenser by completing several TEST DISPENSES.

Refer to error 500. 512 SPED device idle.

Clean the dirty sensor; or replace the note transport as needed. It may be necessary to replace the dispenser. 201 Dispenser detected more than six errors in a dispense This status is generated when there are 6 rejects during the current dispense. If error persists; replace the main board assembly. 557 System device reset. Triton Rl1600 Atm Manual Test the dispenser by completing several test dispenses with the test dispense command.

This is the status after a normal dispense. 33 (21h) Feed failure This error is usually associated with an empty cassette or currency that is in UNFIT condition. Remove any jammed currency. 2. Generated Sun, 30 Oct 2016 18:07:18 GMT by s_mf18 (squid/3.5.20) his comment is here The maximum number of notes that can be dispensed from the dispenser during a transaction is defaulted to fifty.

Remove jammed currency. 2. Reset the cash dispenser. Detected offline error check op state. Refer to error code 535. 552 Card Reader ñ Device received invalid request.

Refer to error 522. 528 EJ sequence error. Inspect the feed path for any jammed notes. Perform the test dispense function several times (two or three). Clear the error and perform a test dispense.

The main board does not see any activity on TCP-IP. 1. Remove and refill the affected cassette using normal replenishment procedures. 303(33h)[3] Lifts are down. Modem may be defective. (If problem persists call Your Service Provider or Triton Tech Support) 6 BGD_NODIALTONE No money is dispensed; screen and receipt display system unavailable. 1. If the voltages are not within tolerance, the cable or power supply may be defective. 4.

If these actions have no effect on dispenser operation, replace the dispenser mechanism and/or the note cassette. Otherwise, replace the dispensing mechanism. Turn the AC power OFF for a few seconds and then back ON to power cycle and reset the cash dispenser. 3. Use clean compressed air to remove any dust or dirt from the sensor lenses.

It is not displayed directly to the operator or customer. If these actions have no effect on dispenser operation, replace the dispenser mechanism. Inspect electronic journal to dispenser communication cable for damage. Complete several live dispenses to ensure the dispenser is working correctly.

If the error persists; replace the dispensing mechanism. 111 (6Fh) Diverter timeout 1.