Home > Error Code > Triton Rl2000 Error Codes

Triton Rl2000 Error Codes

Contents

If the error does not occur again; put the cash dispenser in service. Results: If problem persists call Your Service Provider or Triton Systems Technical Support 95 Multiple cassettes of the same type This is a multi-cassette dispenser error. 1. Inspect the feed path for jammed notes. This status code will appear in the electronic journal as code 32 or 100 indicating the successful completion of a transaction. 101 2-second timeout waiting for pick. (Feed failure). navigate here

ATMs with NMD or Mini Mech dispensers require electronic journals with part number that start with “9600” or “09600”. 2. Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 102 Timeout at Exit Sensor 1. Make sure the connectors are seated securely on the main board and on the electronic journal. 4. Reset the cash dispenser. http://www.accessatm.com/service/atm-error-codes/triton-error-codes/

Triton Error Code 244

Inspect the cables connected to CN2, CN3, CN4, and CN5. Seat connectors or replace the power supply as needed. 2. Clean the dirty sensor; or replace the note transport as needed.

If error persists; reboot the ATM. This will occur if the machine is switched off and on during normal daily operation. If injecting a new cassette ID into the cassette does not correct the problem; replace the cassette. 322(46h)[F] Main motor failure Error code 322 is generated when the main motor fails Mitsubishi Triton Error Codes Inspect the currency for excessive wear.

Inspect the printer data cable for damage. Triton Error Code 33 Note: Dispenser Status (Click Counts) should be run and available before contacting Tech Support 104 Unable to clear width sensor. Make sure the battery is seated secure in the battery holder. http://www.atmdepot.com/triton-atm-error-codes/ Reset the cash dispenser.

Remove any documents blocking the throat opening. Triton Atm Error Code 101 If the cable ends are seated properly and there is no apparent damage to the cable; it will be necessary to verify the continuity of each cable; otherwise replace the dispenser. Clean sensors as needed. is a registered ISO of MetaBank, Storm Lake IA 50588 Home 1-866-787- 4866 | e-Mail | About | Contact Us | Login Products News Services & Support Partner Programs Service

Triton Error Code 33

Verify that all access panels are closed and secured. 3. http://www.atmnetwork.net/support/troubleshooting/TritonRL1600.asp Make sure the connectors are seated securely on the main board and on the electronic journal. 2. Triton Error Code 244 Perform a live transaction. Triton Error Code 151 When done chose, marked as audited. 2.

Make sure the tamper screw is secure to the SPED module. check over here Otherwise, replace the dispensing mechanism. Also note that when Low Paper Checking is disabled; the terminal will continue to operate without printing receipts when the paper spool is empty. Refer to error code 535. 541 Card Reader ñ Com error. Atm Error Codes List

  • Purge the dispenser using the purge command. 3.
  • This error occurs when the logical sequence of the commands sent to the dispenser is not the one expected by the system.
  • If all sensors are operation correctly, and the error persists, replace the replace the dispenser. 42 Transport error.
  • Triton Connect error.
  • Clear terminal error code.
  • If the cables are undamaged, the main board or electronic journal may be defective 151 Electronic journal full The electronic journal on 8-bit machines (9600, 9700, and 9100) can store as
  • Time-out waiting for response or carrier was dropped.
  • Verify that the both ends of each cable are securely connected to its termination points.
  • State by verify if this is associated with error code 151.
  • Purge the dispenser using the purge command.

Inspect all cables for damage. The most probable cause is either mechanical or electrical failure of the note diverter in the note transport module. Verify that main board to electronic journal and the electronic journal to dispenser cables securely seated at both ends of the cable. http://u2commerce.com/error-code/triton-error-codes-144.html If working with an 8100, print a test receipt printer, Verify that the A cassette is in service.

Inspect card reader for foreign objects. Triton Traverse Error Code 917 If they pass, clear the error and place the ATM in service. 2 If working with a 9100 print a test receipt printer Verify the “Cassette 195 Receipt printer out of This error code will place the cash dispenser ìOut of Serviceî.

This status code will appear in the electronic journal as code 32 indicating the successful completion of a transaction. 33 Feed Failure This error is usually associated with an empty note

Use the reject channel error code function to verify the operation of the sensors on the note transport module. Inspect main board to electronic journal communication cable for damage. If error persists; replace the dispenser mechanism. 373 Dispenser machine not opened. Triton Error Code 246 Purge the dispenser using the purge command.

Refer to error 522. 526 EJ device busy. Purge the dispenser using the purge command. If the journal prints successfully; verify that all records were audited by performing the Print Journal function again. weblink Enter management functions menu and place the cassette(s) in service. 383 Dispense cassettes low (ALL).

If error persists, replace the SPED keypad module. 207 SPED not detected This Error/Status Code is valid for units with SPED keypad device installed. 1. If the error code is reported again; replace the CMC module. Make sure the diverter moves freely. 4. Reset the cash dispenser and clear the error.

If the error persists; replace the dispenser. 46 (2Eh) Exit quantified A mechanical failure has occurred. Dispenser failed to identify the dispenser type installed. If the error does not occur again; put the cash dispenser in service. 4. Test the dispensing mechanism by completing several test dispenses.